My "Water Level Low" light comes on every time the "Add Nutrient" light comes on.

Because the water needs to be full when you add nutrients, the AeroGarden has been designed so that the "Water Level Low" light automatically comes on at the same time as the "Add Nutrient" light, to prompt you to make sure the water level is full. The water level needs to be at the "Fill to Here" mark when you add nutrients to prevent their becoming too strong in solution. However, this is the only circumstance when pressing the Reset button resets the "Water Level Low" light. The "Water Level Low" light is normally controlled by the water level itself. (Water low, light goes on - water high, light goes off - when all is functioning normally).

If you have pressed the Reset button on your AeroGarden trying to clear the blinking “Water Level Low” light, you will have inadvertently reset your “Add Nutrient” light timing. Every time the Reset button is pressed, the nutrient timer ("Add Nutrient" light) is reset for another two weeks.

To get the Reset button back in synch with when your nutrients are actually due, you will need to determine the calendar date when you last added nutrients. If you don't remember, look back to the planting date that you wrote on your Tending and Harvesting Guide when you planted your Seed Kit. and count forward in two-week increments from the initial planting date. When the next feeding is due, add your two nutrient tablets, fill the Bowl to the "Fill to Here" mark, and press the “Reset” button (even if its not blinking).. This will resynchronize your “Add Nutrient” light with the time that the nutrients are actually due.